Wireless

Can the 2504 be configured to communicate with APs on one physical port while directing the wireless traffic out a different physical port?  We want APs on 10.1.7.0 subnet to send wireless data to the WLC (CAPWAP) on 1 physical port and then have tha...

Hi All,I keep getting this alarm in Cisco Prime 2.2 send from the WLC 5508AP Impersonation of MAC '5c:a4:8a:d7:f0:02' using source MAC '5c:a4:8a:d7:f0:02' is detected by authenticated AP 'AP_1' on '802.11b/g' radio and Slot ID '0'.I am not sure if th...

I plugged in my new WAP571 wireless access point.  I can ping it, but I cannot get into the device to setup the configuration using the wizard.  How do I get in the device?

Hi I 'm adding to Cisco Prime 3 MSE but it shows me this message : No response from Server. May it be unreachable , or server is down or HTTPS connection to server failed. And start and stop services and also execute this command ( iptables -F, ...

Hi everyone! I have a little issue. In my network we use ISE+WLC with one ssid and dynamic profiling from ISE. The question is- how can configure QoS-options pushing to the WLC, then it must submit it to end-device in access to the radio-BSS (SISF va...

Is it possible to have Cisco CMX to authenticate different floors in a building with different facebook pages?

Hi Team, - WLC: 2504- AP: 1142 or 1702- OS: 8.2.111.0- Config: See attached file debug file  attached - Current issue : the symptoms that occur reconnecting to the wireless LAN client is in place.

DO SOMEBODY KNOWS HOW MUCH BANDWIDHT DO I NEED INTO MPLS LINK JOINING 2 DIFFERENT PLACES OR CITIES WITH WLC  ON EACH POINT??? AT THIS POINT WE NEED INTERCONTROLLER ROAMING ON THOSE WLC SEPARATED ON DIFFERENT CITIES BUT WE HAVE TO CARE THE BANDWIDTH F...

I need to disable the TRACE method on your Internet-accessible web servers. During a PCI compliance scan we received 3 errors. 2 have to do with this TRACE method one has to do with TLSv.10 being disabled. I would like to complete all at the Cisco e...

I am setting up a network for a remote location doing roof wireless. After I configure the APs for Bridge mode ( since some are going to be mesh on the roof) The APs wont fallback to DHCP in order for me to double check configurations. If I change th...

I have a Cisco AIR-AP SAP1602I-E-K9. when I turn it on, the indicator displays red. What should I do?

Hi In our project there  two wism controller and APS are registered there are 28th floor and 210 APS of 1042 if we integrate wcs with these 2 wism controller we can generated heatmaps for  survey for these 28th floor. need advice  and configuration l...