Wireless

Hi all! I'm trying to figure out the Cisco recommended number of hops for clients in a mesh network (indoor or outdoor). I know the backhaul hops (max 8 outdoor and 2 - 4 indoor depending on application... voice should be no more than 2 hops for exa...

Hello Only autonomous APs in deployment installed base has AP1240AG. New AP are AP1602E Need to support VoIP with CP7926G terminals. So FastRoaming and WDS would be needed/desired. From Config guide: One of the pre-requisites of WDS is that all APs...

I have the following setup. WLAN consisting of Cisco 3602 Access Points, a WLC, running on a Cisco LAN. I have Ubiquity Air Routers running in AP mode that acts as Bridges, to which a PLC & Workstation is connected. With no data running over the n...

Hi Everyone!     I want to provide the DHCP IP address for the client PC. How can I configure it on Aironet 1700series Access point connect with 2504WLC. It will be appreciate for promptly reply.Thank you everyone.

Hi All, To have mobility express features, is it necessary to order AIR-AP1832I-x-K9C, with C in the part number? Thanks!

Hi, What is fundamental difference in functionality between an AP with single radio but dual band and dual radio dual band? Why would someone invest in dual radio AP? Someone had told me that in single radio once someone connects at one frequency, it...

I need suggestion from wireless expert on below matter. There two WISM controller for Guest Network in which 210 APS are connected(1040 series) And one 5760 controller is used for Admin Network in which 96 APS are Connected (2602 series) How can we i...

We are a College and Lower School environment, on two campuses. At the College, a major effort is underway to use Apple TV, and iPads for interactive classroom work. The basic of users on iPads and connecting and sharing information through the Apple...

 We've purchased a AIR-SAP 2602I-A-K9 but it wasn't able to produce IP address for client. both andriod and IOS wasn't able to connect to it. any thoughts, what gonna be the problem is? is there any special configuration to do in order to connect to ...

Hi,     What the oid to know the number of clients per SSID ? I use CA Spectrum and Performance Center. Tks,

hi, I have few cisco aironet accesspoints, that I converted to autonomous ap.  Is there any ios command that i use to find out if the AP 1. 11ac or 11n 2. TXxRX streams 2x2 or 3x3  I found out one way is to give following commands #int dot11 1 # spee...

1) Does WLC support SKC + OKC on same WLAN simultaneously? 2) Documentation of 802.11r (FT) is contradictory: Restrictions for 802.11r Fast Transition • This feature is not supported on access points in FlexConnect mode.• For the access points in F...

Hi All,            I am using 5760 wireless controller in my company.my problem is earlier i had a access for removing and disabling a clients  on web based access. but currently i dont have access the same after upgrading the IOS.            what co...

My AP 1830 is located at branch office but I do not want to deploy it in express mobility mode. Can my AP 1830 operate as local mode and communicate with my centralized controller at HQ and DR? My customer do not want distribute mobility express cont...