We have 34xAP (1130, 1240) 2x 4402 WLC and 60x7921 with 1.3.3.1.Is better use WLC 5.2.193.0 or upgrade to 6.0.196.0?2. Is it possible use WPA2 + AES + CCKM?3. Which security setting is best for use for 7921 and fast roaming?
I am hoping someone out there has experience deploying a WLAN to support Skype.Not being a voice guy usually relying on the different QoS profiles for voice and data I see an issue with skye potentially not getting the correct QoS profile.I could alw...
Hi guysI am installing a CA certificate in the ACS Solution Engine, the certificate is succesfully installed, then I restart the appliance normally, but I can't use HTTPS transport. Applying the check box "Use HTTPS Transport for Administration Acces...
Does anyone know a link or where I can get information about the following:-My customer requires the hostport on an access switch to be allocated to a specific Vlan based upon the AD Group that the user is a memeber of ? I am planning to setup NAC i...
Hello,looking to find out how many AP1230s I would need to support 150 clients in a large conference room. Before anyone starts in on me these are the only APs available. Clients will be a mix of laptops using a variety of different adaptors.Than...
Hello,I don´t understand very well the difference between coverage area and perimeter in the WCS Map Editor.I only want that APs coverage offer service inside the building and then avoid that a person can connects when he is outside the building.To d...
Hi,I have cisco AP 1242 AG connected to the WLC 4400 and two antenne viz.AIR-ANT2460P-RandAIR-ANT1728but i am not getting thruput up to the mark. pls suggest to improve the thruput.in most of the places i get low signalwhat needs to be checked. tell ...
I have a 1242 that in WCS is reporting as Not Associated. I clicked the AP name assuming I could re-associate from the drop-downs for Primary and Secondary, but was promptly was warned I could go no further until the controller issue is resolved.How...
We have a Cisco 4402-25 running software version 7.0.98 and we are interested in getting a new 5508 controller. My question is can I load balance between these two or can one act as a master and the other a slave? Thanks
hi all,i am using 5508 WLC with 1042 aps.i have guest WLAN thru which Guest users are connected.is there any option in Controller to Limit the guest user Connectivity session?guest users are created in WLC itself....in local net usersRegards,Venkat
On our guest wireless, at times when a user shuts down their laptopand powers back up they are not asked to re-authenticate.The only security is a login and password then the user is tunneledto our 440 in our DMZ then out the internet pipe.My questio...
Just looked at report after having upgraded to WCS 7.0. It is reporting that SSH is disabled. It is enabled on the controller. The timeout value was set to zero for telnet access. No indication was given that the telnet timeout value also affecte...
Hello everyone,I'm a beginner in the world of wireless, and I wonder if in a WLC 2125, I need to configure a physical port to the AP Manager or just need to configure the AP Management and AP Manager will automatically accept.I am awaiting response,...
Some of you can provide me with material to set in a WAP4410N two different SSID with different IP segments. I set an ssid guest internet access only and the second ssid for users of the LAN, LAN access only ... I appreciate your help, Best Regards,W...
