Hi We have two ssid. Both have been configured with "All" in Radio Policy(WLANs ---> General ----> Radio Policy ----> All). but on user side(by command netsh wlan show interface), why one ssid is only having a band while the second ssid is only havin...
Forum Posts
is it possible to join cisco aironet 2700 series access point with Cisco 3650 catalyst switch
We have run into issues where only few clients cannot associate to our corporate SSID. Debug synopsis below Aug 08 11:55:18.039*apfMsConnTask_3Client made new Association to AP/BSSID BSSID a0:23:9f:fa:d5:62 AP NZCHC5NET55Aug 08 11:55:18.041*apfMsCo...
Hi all. I'll try to keep this simple. Using a 5508 WLC with HA, and 2702i AP's I am trying to configure a flexconnect AP to be used on a site which whilst it has routing back to us we do not manage. This means I have no control over the VLANs o...
Resolved! 40/80Mhz channel with 2802e on 2504 WLC
Hi, we just deployed a new infrastructure based on 16 2802E APs on a 2504+HA WLC in Local Mode with RRM configured both on 2.4 and 5Ghz. WLC is v. 8.5.131.0. I have selected on the DCA on 5ghz these options DCA5ghz Unfortunately, even aft...
Re: 5508 WLC Tx Power Control(TPC)- High Density Deployment My Client's WLC is globally set to Fix AP power level to level 1. Is it possible to change this setting on an AP Group basis? Want to auto adjust power for a certain location. I...
situation is a 3850 and a 2504 on the same LAN. The 2504 is connected to the 3850. there are 30 APS in the network and 9 of them cable directly to the 3850. The 2504 AP management VLAN is 253 and the 3850 is configured as 254 whenever wireless mana...
UcraínoInglés---------------Detectar idiomaAcerbaixanoAfrikaansAlbanésAlemánAmháricoÁrabeArmenioBengalíBielorrusoBirmanoBosníacoBúlgaroCanarésCasacoCatalánCebuanoChecoChinés (simplificado)Chinés (tradicional)CingalésCoreanoCorsoCrioulo haitianoCroat...
Hi guys, We have a customer asking us to relocate an old vWLC onto a IaaS platform, and I'm trying to confirm whether it'll be able to operate there or not. You'll have to excuse me - i'm not that familiar with the Cisco wireless controllers. The c...
Hello guys I have one controller WLC 2504 with one license of 15 Aps and another license of 5 APs. After I upgrade him to 8.0.152.0 just the 15 license come to active. I saw messagens in log saying that rejected new registers. After I change license ...
Resolved! Configuring a/n band
Hi We can configure a/n band via wlc, but can we configure a band associated with first ssid and n band associated with second ssid? thanks
Resolved! Spectrum Expert analysis - WIFI Problems
Hi, We are getting intermittent wifi problems at a particular site and have been advised to use Spectrum Expert. Below is a screenshot of the area that is a problem. The access point in the room currently has 23 clients on it and is on channel 52. ...
Hi everybody, I'm trying to set up a WS-C3650-24-PD-S Wireless Controller but I read in its datasheet it has the option for a "primary upgrade license" and a "1 access point adder license".My silly question is: does it mean I need to purchase the Pri...
I have a Cisco AIR-CAP3602I-A-K9 access point that started acting up and it's my belief that it went bad and I need to replace. I had to take the AP down and it's currently removed from my network. I now have a black hole in coverage and I need to in...
why not all access points on wireless controller have the same Tx power level :
