Hi I recently installed Cisco ISE 2.3 and I want to create a policy that only Users and computers Join to the domain can connect to the network. I'll use the policy below: I also have the following configurations: But a number of users occasiona...
Forum Posts
How do I copy a Prime Backup from repository default repo to repository FTP in CISCO Prime 2.0
I got a new CISCO AP1832i-S-K9 Need firmware upgrade to make it work alone. However i cannot download firmware from Cisco.com. It said "To Download this software, you must have a valid service contract associated to your Cisco.com profile."
Hello.I installed virtual Prime 2.2 with temporary license on ESXI. Now temporary license is end and we bought base license. But Web interface of Prime is blocked, because temporary license is end. On cisco.com/go/license I must insert " Product ID"...
I had some problems to configure the 1850 ME until I've selected one address in 192.168.1.0 network. Then everything it's easy. But my customer gave me this address to put the AP Controller in her network: 10.10.10.222 and when I put: and when I...
Resolved! Why can't assing 10.10.10.222 IP address to Cisco 1850 Mobility Express Controller? And keep.
Yesterday I opened the discussion: https://supportforums.cisco.com/t5/getting-started-with-wireless/why-can-t-assing-10-10-10-222-ip-address-to-cisco-1850-mobility/td-p/3349065 And when I thought was closed I see: Not solved. When I execute the...
Has anyone else experienced AP's crashing on 8.2.166.0? We randomly get AP's crashing with the following error: Message: Access Point 'AP19-2602-0cf5' associated to controller '10.0.1.2'. Reason for association 'AP Crashed Due To Software Failure'...
Ok. I have many network segments with Clean Air AP's linking fine to Spectrum Expert. I have one segment on which none of the 2802's can link to SE.. what are the port requirements? At this time we see no difference between the working segments and ...
HI Team, we are planning to downgrade IOS Version of CISCO 4500 switch from 3.7.2E to 3.6.7E. Please let us know if we can get there in 1 step without breaking VSS. Can we use ISSU or do we have to take outage? http://docwiki.cisco.com/wiki/Ca...
Hi all, I'm looking into this antenna and was able to find a drawing with some dimensions with parts called out. However, it didn't specify the material of the parts like the bolts and mounting arm. Is it possible to obtain this information? Also w...
Hi, I am conducting and audit of the number or ISDN lines within the organisation and not sure how to view how many lines are available for each router. The show isdn active only shows when calls are connected.. Thanks
Dear Expert, As I know, there is RRM to control the TPC power automatically to all AP controlled by WLC. Is there is any reason to create RF profile to set limit the power range in TPC setting under High Density environment? Thank you!
Hi, we have about 40 AP:s mixed: AIR-CAP2602I-E-K9 AIR-LAP1142N-E-K9 We started getting alot of these errors, APs gets disconnected. it drops from abot 40 connected APs to about 30. Then they come up again. AP:s dont reboot but they are flapping and ...
Hi, While 802.11ac is the radio capabilities of an Access Point, why do we see the controllers classified as 802.11ac wave 1 and wave 2 respectively? Will using 5508/8510 controller in the deployment prevents from using the 802.11ac wave 2 advantag...
Dear Members, please suggest me which basic Cisco AP I should purchase for my covered office area i.e. (9x21)mtr.? where concurrent local network users are 10-15. where these users will use ERP client system, MS office and Outlook 2016. All users are...
