cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
637
Views
0
Helpful
0
Replies

Reporting on Hardware status using AXL

Hi there,

On the RTMT there is a pre-configure alert called HardwareFailure. The description of this alert states:

"This alert occurs when the HardwareFailure event is generated. This indicates that hardware failure event (disk drive failures, power supply failures,...) has occurred."

Is there a way to check using one of the AXL interface on CUCM on that hardware status (same as the pre-configure alarm) that the CUCM VM is sitting on top to check that there is no alerts? I had a look around the RISService interface but only found CPU Memory etc..

thanks

alexis

http://www.netpacket.co.uk/ http://www.blog.netpacket.co.uk/
0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: