08-08-2016 09:19 AM - edited 03-05-2019 04:27 AM
Newbie question here...
So I've been tasked with replacing an old 2811 router with a 3560 at a WAN site. This is connected from the existing 2811 back through a Gigaman telco circuit with a few different handoffs back to my core with a 3550. In the past, we used a GRE tunnel to ensure that multicast was working correctly.
I want to implement VRFs as well (but that might be a different animal), so I'm not sure how to go about doing this. As I just found out, our 3560 is at over software revision 3.3 where GRE functionality was removed.
Is there a good substitute way to make this work? Or am I going about this the wrong way? I'm fairly new and not sure where to go from here.
Thanks,
Jeremy
Solved! Go to Solution.
08-09-2016 12:20 PM
Hi, Jeremy,
I recommend you also post this question to the Cisco Support Community for additional information and feedback.
https://supportforums.cisco.com/
I hope this helps. Thank you for participating in the community.
Kelli Glass
Moderator for Cisco Customer Communities
08-09-2016 12:20 PM
Hi, Jeremy,
I recommend you also post this question to the Cisco Support Community for additional information and feedback.
https://supportforums.cisco.com/
I hope this helps. Thank you for participating in the community.
Kelli Glass
Moderator for Cisco Customer Communities
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: