cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
873
Views
0
Helpful
1
Replies

Trouble with a C9300-48T-e switch

stuartmair
Level 1
Level 1

Need to reset to factory default-how is that done in the C9300-48T-E switch.

1 Accepted Solution

Accepted Solutions

szeya
Cisco Employee
Cisco Employee

there is two options:

First option :

Step 1 Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds.

Step 2 Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch restarts.

Second option :

C9300#write erase

Erasing the nvram filesystem will remove all configuration files! Continue? [confirm] yes

Thanks

View solution in original post

1 Reply 1

szeya
Cisco Employee
Cisco Employee

there is two options:

First option :

Step 1 Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds.

Step 2 Continue holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch restarts.

Second option :

C9300#write erase

Erasing the nvram filesystem will remove all configuration files! Continue? [confirm] yes

Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: