cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2184
Views
1
Helpful
5
Replies

Spark-Registered In-Room Control on CE Software Getting "User not authorized"

I am getting "User not authorized" when trying to issue this command on an MX300-G2 registered to Spark:

xCommand HttpFeedback register FeedbackSlot: 1 ServerUrl: "http://192.168.21.129:5000/codec" Expression: "/event/UserInterface/Extensions/Widget"

*r HttpFeedbackRegisterResult (status=Error):

*r HttpFeedbackRegisterResult Reason: "User not authorized"

*r HttpFeedbackRegisterResult XPath: "/HttpFeedback/register"

** end

I logged in with both a "room control" user, and an "integrator" user.  Neither works.  The fact that you can create the accounts would indicate this is supported.  Am I missing something?

Thanks.

Sal

5 Replies 5

Justin Ferello
Level 5
Level 5

Salvatore,

xCommand HttpFeedBack is not supported on Cisco Spark registered endpoints.

See the section "Limitations" in the link below:

https://collaborationhelp.cisco.com/article/en-us/n5pqqcm

Thanks,

Justin

Thank you,
Justin Ferello
Technical Support Specialist, ScanSource KBZ

So the obvious next question is - when will this be supported?  Is there any way to use In-Room Controls on a Spark Registered endpoint?   Is this coming?

Sal,

That I am not sure of.  However, In-Room Controls work for the most part.

Thanks,

Justin

Thank you,
Justin Ferello
Technical Support Specialist, ScanSource KBZ

I'm almost there.  I registered my peripheral (web server) like so:

xcommand Peripherals Connect ID: "503f5601da14" NetworkAddress: "http://172.16.5.65/codec" Type: Other

And then I registered my Events:

xfeedback register event/UserInterface/Extensions/Widget

and I get this which is great:

*e UserInterface Extensions Widget Action WidgetId: "widget_2"

*e UserInterface Extensions Widget Action Value: ""

*e UserInterface Extensions Widget Action Type: "pressed"

** end

*e UserInterface Extensions Widget Action WidgetId: "widget_2"

*e UserInterface Extensions Widget Action Value: ""

*e UserInterface Extensions Widget Action Type: "released"

** end

I'm just not getting anything on my web server.  What's the missing link?  There's got to be a way to tell the system to send the out of the widget interactions to my Web server.  I'm almost there, but I can't seem to get it.

Sal

mmihalyf
Cisco Employee
Cisco Employee

Looks like the issue is over:

https://collaborationhelp.cisco.com/article/en-us/n4lhv2s

"Increase in Administrator and API Access

You can now create an Admin user from the devices Advanced Settings."

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: