I need retransmission to occur but FTD is not forwarding them.Is this related to the tcp map? tcp-map UM_STATIC_TCP_MAPno check-retransmission <------------no checksum-verification
Greetings,I am trying to establish CFM connectivity using emulation (CSR1000v).I am running VPLS (Manual discovery) for end to end connectivity.The topology in use is CE4 - PE2 - PE3 - CE6Connectivity in place , what am not able to get the remote mai...
Pim{ rp{ static{ address 10.126.1.1{group - ranges{239.0.0.0/24}}}}{Int Fe -0/0/0.0 mode sparse;Version2;}Try to migrate Juniper configuration to Cisco ASR but configuration not working properly
Hi:
In general terms: does any part (device) of a DSLite process function differently when the CPE wants to reach a private ipv4 destination than when it want to reach a public ipv4 destination?
That is, within a DSLite environment: if a subscriber w...
configuration card type 0 4controller e1 0/4/16framing crc4cem- group 0 unframingline code hdb3After this configuration controller still downE1 interface is upWhat will be the issue, anyone suggest ?
Hello
I have server-mapping in network segment routing in operator
i want tp know if server-mapping need a License to install or not ?
I wait a reply from expert segment routing cisco
Thanks in advance
we have an asr1006 connected with a lacp (mode active) with its 2 tengiga ports on a virtual port-channel between asr9922Cisco IOS XE Software, Version 16.09.04The asr have started randomly throwing out these errors:Aug 27 06:34:12: TenGigabitEtherne...
Dear Cisco Community,
One of our customer has the following business need:Currently, the customer has one border router with three ISPs. As usual, each ISP delivers only one public IP address to that router. However, there is an emerging need to have...
Morning All,New to the forum and had a question regarding adding a module to a 903. Module is a A900-IMA2ZBeen looking around and saw that you can replace a card without powering it down, but can you add a new card to the system without powering it d...
Hi,
I am new to VPLS. I am trying to test VPLS in the lab initially. My set up is extremely basic at present.
CE1 (3560CG-8) ---- PE1 (3850-12XS-S)----PE2 (3850-12XS-S)----CE2 (3560CG-8)
I have followed the instructions on the following Cisco c...