Can anybody help me regarding Network configuration manager. If we want to deploy NCCM in our network then what configuration will be required in network devices.
Forum Posts
I am working on a eem script and struggling to display a script output line by line on a syslog. It show mab all sum and the result is usually like this : Interface Client Mac Authen Status Gi1/0/1 aaaa.bbbb.cccc SUCCESS Tw2/0/2 cccc.dddd.eeee FAILE...
I'm trying to patch install 6ea ise consisting of pan/mnt and psn in version 3.2. Does downtime occur between tasks?
Hi,Switch - CISCO Catalyst 2960-48TT - NTP time sync issue.NTP server is Windows Server 2022 (Domain Controller).Pls find below command output step by step for easy understanding.CSA_SW#show clock detail.19:28:40.268 IST Fri Dec 8 2023Time source is ...
Greetings,I have two questions about building bfd session:1. As the customer requested, we tried to set bfd multiplier 2 & bfd minimum-interval 5000 on our bgp neighborship, it failed. But we then tried 3 & 500 (refer to the existing bfd setting on o...
I saved the project normally yesterday and when i went to open it this morning I got this error message. Is there anything I can do to recover my project?
Just received some 8300s and am attempting on configuring the dial-peers and voice-ports and am not having any luck. I must be missing a step pror to being able to configure these. I have a config from my 3925E's that I am trying to duplicate. I u...
I have a trolley load of end of life switches, firewalls and access points that I was going to skip, but then heard there was a takeback and recycle program run by Cisco. has anyone used this program? is it available in the UK? I have raised 2 RFI...
Hi, my name is Thien.My case is that I have configuration static NAT on the ASA allowing address 3.0.0.2 (f0/0- R2) to through the ASA (g0/3 4.0.0.254)object network OUT_REALhost 3.0.0.2object network DMZhost 4.0.0.10nat (outside,DMZ) source static O...
Hi Cisco Community. I would like to setup a separate DHCP pool for the cctv VLAN with a separate IP address range set the pool size to number of devices +1 and static bind them all, then set firewall rules to stop the home LAN from reaching the cctv ...
Resolved! DHCP Failed APIPA in Use
So I am trying to get all of these PC's to pull an address via DHCP. The two on the bottom left labeled Finance PC and Operations PC respectively are giving me the error DHCP Failed APIPA is being used. Everything else was able to work. My question ...
Hi everyone, I have a new but configured basically Cisco 3560cx 12pd-s. I keep getting the dhcp conflict error messages everyday. I have an Asus GT AX-11000 router that is connected to my new Cisco 3560cx 12pd-s. I somehow managed to do a basic confi...
Hi, I'm having some troubles with the network. I tried different setups and this is one I have got. I followed different setups found on internet and tried to connect everything accordingly, but when it comes to get IPs for PCs, the DHCP ends up fail...
Resolved! Firepower Extended ACL does not work
Hello everyone, we are currently working on an issue related to ACLs. We have two branches (site-to-site VPN) and sometimes we need to enable communication between two computers (each computer is in a different branch). We don't want to allow all com...
I'm trying to get a file on the ise local disk using ftp in filezilla. Set the server listener to my ip in filezilla In ise, copy disk:/<file name> ftp://<My ip>But filezilla didn't respond The results also failed. Does anyone know why?
