Dear All
I have two wireless controller model 3504 we need to configure redundancy for primary and secondary . i have total 26 access point and two controller 15 AP license installed .i want all AP working with one controller at a time once primary i...
Hi,AllI am using cisco 2911SR router try to upgrade phone firmware in ip phone 8945 sires through TFTP but the tftp erroe for uploading time please see the bellow ...CME Router#copy tftp flashAddress or name of remote host [192.168.20.144]?Source f...
Hi AllI have configured cme 2921 router and 7 PSTN line. When there is incoming and outgoing calls, an available port will indicate a green light but after the incoming and outgoing call stops, green still there and need to restart the cme again. p...
Hi All My proplem is, when I call from my CME to an other PABX, the call was established successful and call transfer another extension that time call disconnected. internal transferring not disconnecting all PSTN line connected through FXO por...
Hi AllThe incoming call transfer I cannot possible to Sip to Sccp phone sccp to sccp is transfer is working .Sip phone 8961sccp phone 7945,6921please check configurationvoice service voip allow-connections h323 to h323 allow-connections h323 to sip ...
Hi This is the incoming call to reception phone please check the situation no 1,2 1. SITUATION NO. 1 Caller : dialed 4981800 FXO port 0 : green light ONSip...
Hi vivek i try to use battery reversal but the port same issue please check the voice-call status LCC-SIPOREX-CME#show voice call statusCallID CID ccVdb Port Slot/DSP:Ch Called # Codec MLPP Dial-peers0x15BE 3924 0x3D1534D...
