Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
10,000 results
Sorted by:
04-26-2024
01:19 PM
I create a Named ACL FILTER-COM1 to permit 162.98.8.15 0.0.255.255 but deny any out. Will the Wild card allow IP's at a lower value such as 162.98.5.6, or will deny it, i understand if the wild card ...
Labels:
04-24-2024
06:35 AM
Hi All, I have a couple of C9300 L3 switches that are connecting to an ASA firewall. The NTP and the syslog server for the switches are located behind a firewall. When one of the switches request/s...
Labels:
- Labels:
-
Other Routing
11-24-2019
04:59 PM
Greetings, i want to configure a router (ISR 4321) to always ignore the startup config (if one was set) so it always enters Zero Touch Provisioning. Is there a way to do this? Many thanks i...
Labels:
- Labels:
-
ISR 4000 Series
04-22-2024
02:31 AM
Hello everyone! We have ASR1001x with fullview and ipsec tunnels. We use local policy to forward packets from PA addresses to their respective gateways. When the traffic load is high PBR stop workin...
Labels:
- Labels:
-
ASR 1000 Series
04-23-2024
12:36 PM
Can someone tell me how do I do routing here ? it does not matter if it is static or dynamic I just want to ping same vlans and also I dont want to have different vlans to be pinged
Labels:
- Labels:
-
Other Routing
-
Routing Protocols
Hi all! English is not my first language, so I am sorry in advance if my words confused you. I tried my best. As far as I know, CEs don't have vrf in general, so CEs would use ipv4&ip...
Labels:
- Labels:
-
Other Routers
Created by
Wizard4777
in Routing
04-13-2024
07:52 PM
04-13-2024
07:52 PM
I have set up as above. I am using starlink at one of my spokes. I am not able to get to pass VPN traffic even though show dmvpn shows that the vpn is up.
Labels:
- Labels:
-
Other Routing
01-16-2023
11:46 AM
Recently, when I log into my switches (SG350X-48), the webpage is super slow to load. it shows "processing data 60%". then sometimes it stops. sometimes it doesn't finish. sometime...
Labels:
- Labels:
-
Other Routing
04-22-2024
05:24 AM
Hi All, I have 2 networks connected via OSPF. I need to route the connected networks to a third network via BGP. I noticed that BGP peering is established but no entry is visible on the routing tab...
Labels:
- Labels:
-
Other Routers
-
Routing Protocols
Hello, I need your help - currently we have a 2921 Cisco router connected to dual ISPs using "gi0/0 & gi0/1" and we are able to connect to either ISP successfully. Once we connect gi...
- Tags:
- Dual ISP connection
Labels:
- Labels:
-
LAN Switching
-
WAN