Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello!I use a script its-CISCO.2.0.3.0.tcl for AA services in CME 10.5. Script config:!application service aa flash:its-CISCO.2.0.3.0.tcl paramspace english index 0 paramspace english language en param operator 21 paramspace english location flas...
Hello, We are using a MVA and other tcl scripts, that uses vxml. Cisco 29XX and 39XX routers listed as End of Sale on 9.12.2017 and ISR 4 k does not support vxml. What can we use as a voice GW for MVA and other vxml applications now ?
I have a question about mixed shared lines on CME. When you create a shared line for SIP and SCCP phones, under which section are you supposed to put the common settings such as forward to voicemail and what not? What happens if you have conflicti...
Hello everyne, Recently, i have added additional license in CUCM but before doing this, i forgot to take snapshot of exist details of license, so i am not able to understand the weather it is installed or Not. I uploaded this license to resolve ...
Hello, Cannot find information.
Hello, We recently migrated from MGCP to SIP. The problem is that now only the hard phones can make outbound calls but not the soft phones. They both have the same CSS which means that once the hard phones can dial out the soft phones should be abl...
I configured the interface as follow interface FastEthernet0/3 switchport access vlan 201 switchport mode access switchport voice vlan 200 spanning-tree portfast! The IP telephony take IP from VLAN 201 not from vlan 200. I attached a wireshark lo...
. My first post disappeared after editing .... isn't editing allowed? ? ?!........ Does anyone know of a table like the following for all Cisco phones? . I started putting one together but it's turning out to be a lot of work. And a lot of the cu...
I would like to set the caller ID sent to the PSTN based on a DN pattern. For example, 6xx extensions would show caller ID of 555.6666 and 7xx extensions show caller ID of 555.7777. I thought this would be done with calling party transformation but...
I have a 4331 Version 15.5(3)S4b, router with a 4 port FXO card.The system is running MGCP. CM 10.5 Having issues with caller ID. Calls come in as unknown.If i do a shut/no shut on the voice port, the caller ID works, ONCE.Then all calls are back t...
We had an issues where our CUCM Subscriber server went down due to a power failure. All the phones registered successfully to our CUCM Publisher at another location and people were able to make outbound calls. But the people at the same location as t...
Is there a setting on CUCM 6.1 somewhere that allows the Caller ID of the person being forwarded to show up on the phone of the forwarded call. ie. I set up call forwarding for my desk phone (CUCM 6.1) to go to my mobile phone. The caller ID that ...
Hello Community, We have CME router and IP phones in the company. Internal calls are working fine. My next step is to enable external calling via FXO and want to enable Auto Attendant service. I have this version of of the 2921 router and CME version...
Hello All, Currently our CUCM backups are running with Freeftpd. I would like to check the credentials for SFTP. I couldn't find any good doc for SFTP commands to check/change the credentials in SFTP , Earlier guy left the company and i need to pe...
