Network Management

How do I set putty tobe my SSh client for LMS

Hi there,I discovered a problem with Functional View in Portal 1.01 with IE 7.0 and FireFox 2.0.13.All Portlets are without content in that View.With FF2.0.0.2 content will be shown.In ReleaseNotes it is stated that IE 7.0 and FF 2.0 are supported.Ar...

Hi everyone,I have a question on a credential issue we encountered at a customer site during implementation of CWLMS 3.0.Customer applied 2 sets credentials for initial discovery. As expected some of the devices were found but failed on the first cre...

We have some old Terminal servers that we would like to try and use to give access to multiple console ports for our switches and router in our computer room.The problem is that the terminal servers we have all have UTP connectors on the back so can'...

This is a quick question in need for a project but if at all possible is there a definite number on how many protocols are there in TCP/IP sweep of protocols?Thanks

I have Cisco 877 ADSL router and 8Mbps bandwidth, I have 2 subnets on my LAN for each subnet I want to dedicate 4Mbps.Weather it can be done by policy map or traffic shapping.What is best configurations to apply on Cisco 877.

Hi,currently i wanna use MRTG to generate the simple network usage graph on my Cisco 7204 ATM interface.But when i follow the instruction given,it show:SNMPWALK Problem for 1.3.6.1.2.1.1 on L14SW1@10.75.23.140::::::v4onlyI wonder if there is any info...

I was installing lms 2.6 onto a server that already had Cisco Security Manager installed. It had common services 3.0.5 already installed. When I went to intall ciscoworks lms (doing an upgrade install) the common services disk which has ciscoview o...

Hi,we installed a LMS 3.0.1 on a Windows 2003 Server and we changed its name last week. We followed the steps for changing the name to a server but the CTMJrmServer process doesn't start, its state is "Waiting to initialize".These are the error messa...

Hi,To override the ExceededMaximumUptime event by creating a custom group like "PPP Interface" and adding rule Interface.Type contains "PPP".We need this to override the ATM and ADSL like interfaces that use PPP but are not ISDN based.Then after the ...

We have implemented a new voip servicethe service runs over 4506,4507 and 6509 switches running ios.We have implemented qos using the class-based Model on the 4506 and 4507 kit so are able to use the cisco-class-based-qos mib for these devices.We how...

Hello,Since upgrade from 3.0, now using LMS3.1 HUM get a Whitescreen, all portlets disappered from HUM main window. Administration sites of HUM are still reachable.LMS is in ACS mode and HUM has been registered to ACS(4.0) server as well. What can we...

Hi,Does anyone know how to remove the requirement that usernames be a minimum of 5 letters for the local usernames database. I cannot link Ciscoworks to using Active Directory under AAA, as my domain username is only 4 letters, and hence I cannot cre...

I'm running LMS 2.6, and the autodiscovery process reports 150 unreachable devices. These devices turn out to be Cisco light weight access points. As LWAP do not run SNMP, but do run CDP, LMS sees them but cannot understand them. I know it is possibl...