Network Management

Hello, I would like to ask if there is any way how to configure mgmt0 interface as a source interface for SNMP initiated TFTP copy.Unfortunately it looks like it can be configured just for virtual interfaces (Loopbacks) or nondedicated interfaces (li...

Dear Team, Currently i have ASA 5525 that configured SNMP information sent out through management interface of ASA, but it is not work. And i try to use another gigabit port instead, it works fine. So what was the problem on management of ASA. Thanks...

Hi, I´ve now configured my CPI (2.1) for receiving all syslog and SNMP Traps sent from my switches (catalyst 2960s). Everything works fine so far.Now i want CPI to send an email for the syslog event "security violation". I can see this event in Syslo...

Hello All, I need a script that matches a syslog message, extracts a mac address within the message and then runs a command for a variable matching the mac address. This is to be done on a WLC 5760 running 3.6.2. I need assistance with action 001 and...

Hello, I used LMS before to generate custom reports. Now with Prime I'm a little bit annoyed of the reporting functions.I want to generate a inventory report for all 1841 Routers where I can see, which type of HWIC/WIC Modules are used.Something like...

We upgraded PI 2.1(2.1.0.0.87) to PI 2.1.2 Maintenance Release.  Under -> Administration -> Software update - it showsPI 2.1.2 Maintenance Release installed "yes"Pending restart "no" However, if you click on help(?) -> about Prime infrastructure -> i...

It's SmartNet time!Instead of doing a lot of manual work, I figured I'd just run a report from Prime Infrastructure 2.2.1 to get our wireless controller serial numbers. Most of these are AireOS controllers in HA SSO pairs. Prime appears to only repor...

I have a C4507 core switch that because of a NEC phone system, we are having some issues with calls. What I need to do is to shut of the ARP IP monitoring on the switch. I have the command monitor event-trace arp and want to know if "disable" will st...

Hi all,I'd like to know the following: if an embedded Oracle database crashes, with no reliable backup due to hardware problems, is it possible to install a new database recreating the schemes, like an external Oracle database, in some way that Cisco...

I'm trying to troubleshoot a NAT problem in a new installation.I'm running Network Assistant 5.8.My question is about the "Ping and Trace" function under the Troubleshooting tab in the interface.From my PC's cmd window, I can ping any active device c...