Routing

Our remote site has a 3845 router running MPLS to connect back to our other 3845 locally. The ISP has provided us a layer 2 sonet connection with no other configurations necessary with the exception of configuring the layer 2 portion on our side. Bot...

Hi all,I have a Cisco1751-V with 2 ISDN interface. I configure the system in mode network: interface BRI0/0 no ip address isdn switch-type basic-net3 isdn overlap-receiving isdn protocol-emulate network isdn layer1-emulate network isdn incoming-voice...

I have a 3845 running IOS version 15.1(4)M8 which has very high CPU and interupt:CPU utilization for five seconds: 73%/70%; one minute: 78%; five minutes: 75% PID Runtime(ms)     Invoked      uSecs   5Sec   1Min   5Min TTY Process   64   128368276   ...

All,I am trying to configure a vlan for fa2-fa9 on my 1811.What I "need" is for the vlan to forward to the dhcp server for IPs and allow internet access as well.The helper address is the address for the dhcp server.Any help would be greatBelow is the...

Dear AllThere are two locations, site A and site B. I am confused with it. Any one can help to understand it? The site A and B are connected with two paths. One is MPLS and another is VPN over internet. we want MPLS as primary path and L2L VPN as bac...

All,I have a 1811 that is working right now but I cant seem to get the vlan for switchports to talk to the dhcp server and the internet.Here is the config........ Current configuration : 3657 bytes!version 12.4service timestamps debug datetime msecse...

It seems like everything is "ISR" or "ASR" these days. I don't need or want Wi-Fi, voice, data, QoS, VPN, IPS etc.  I just want a router that can route between a LAN interface and 30Mb WAN interface, with nothing fancier than a single static route. I...

How do I configure a wireshark capture on the ASA?

Hi guys.Please se my output below. It is from my router Cisco 2851 with 120 users behind. As you can see I have a lot of bittorrent traffic. I don't wont to block this kind of traffic, I would just  like to see it on the last place. Can anybody help ...

Hi, just recieved some new Cisco 2901 routers (replacing older 2811's).  It came with c2900-universalk9-mz.SPA.154-3.M1.bin loaded on.  Is this the best IOS for this router?  There is one newer one but its an early deployment release.  There is an ol...

Hello I am trying to setup a p-p serial interface link and see the following: Config on side A interface Serial0/2/3 bandwidth 512 ip address 192.168.241.1 255.255.255.252 ip virtual-reassembly in encapsulation frame-relay load-interval 30 serial res...

If a non existent route-map is referred in a redistribute command . How does it effect ?Example configurationaddress-family ipv4 vrf VRF:MMS:MGD:XLC:190  redistribute connected route-map MGD_XLC  redistribute static route-map VPN_XLC  no synchronizat...

Good day I'm not a Cisco trained technician but i have a idea what to do when setting them up. But this one is throwing me for a loop. i received a Cisco 887 Router Part number: 341-0135-03 to add a new ISP's details.    Reset the router using the re...

HiYesterday afternoon we experienced an issue where 2 Cisco 7609 (Sup 720 3BXL) routers functioning as PE devices maxed out the CPU for a lengthy period of time.  This caused huge BGP instability.  The main processes taking the CPU time were either t...