Routing

Hi all,Site A and Site B are connected with 2 links (1G and 100Mbps) and configured using OSPFv2.Site A and Site B equipment are from different vendors (SiteA is Cisco, SiteB side is non-Cisco) and we are worried that in the event of firmware upgrade...

How is one-way PPP PAP configured? I have the following in my configurations.  Server huss0036_L3_R3: hostname huss0036_L3_R3 interface Serial0/0/0ip address 203.168.190.9 255.255.255.252encapsulation pppppp authentication papclock rate 128000  Clien...

Hi,We have LTE backup connection on Huawei E3372 connected to USB2 port of RV320. Modem is not visible in RV320 and it is not known as compatybile with firmware 1.0.6 (https://supportforums.cisco.com/sites/default/files/rv32x_usb_compatibility13.pdf ...

I've made an point-to-multipoint frame-relay network, one with typical hub and spoke. While each spoke's EIGRP routes are being shown in the routing table, connectivity can't be established. R1 (HUB)interface Loopback0ip address 1.1.1.1 255.255.255.0...

Yesterday, I tried using normal traceroute to see my hops to Google DNS. Every time I issued that command on my router, it would fail before hitting the internet. Even when I tried an extended traceroute, without a source, it would fail before gettin...

Hello.I am personally a little fresh to the engineering side of networking but have experience in setting up and troubleshooting networks that have been set up. I've been tasked with putting together a network for a campus where the on site admin has...

Hello, I'm pretty new to my studies, but have built a small home lab for practice.  Today I configured two 2960 and one 3560 with with separate vlans and trunks.  Everything seems to be working other than DHCP.   Running config from router: R1#sh run...