Hi All,Can someone advise me when you daisy chain two Cisco 8831 conference units can you then use two sets of external mic kits (one set connected to each unit) or are you still limited to one set?ThanksJason
Hi everyone,Cisco Unified CM AdministrationSystem version: 7.1.3.32900-4 Does someone know how to delete a huge list of services in "Device Profile" when you select a specific user?I have users who has a lot of subscribed services. Always the same is...
Hello ,i have a problem with a CUCM 6.1.5 Publisher . When i change some device entries , perhaps " Phone load name " on a Cisco 740 phone or the partion , i can't save the changes . If i push the save or reset button nothing appears. I check it wi...
Hi,What are my options when it comes to networking 2 Unity Connection clusters (both on BE6K HD servers), say one CUC cluster on the east coast and the other on the west for the same company?Per Design Guide for Cisco Unity Connection Release 10.x - ...
Dear all, i have a pre sales question.i have propsed a CUCM 8.X to a custome along with UCSS support for 3 years which is mendatory.in order for the UCSS upgrade to work does CON-ESW part numbers are also required as well.i am very confused in this s...
I am trying to create a new Route Pattern for a 511 service here in GA. It works fine with 411, so I essentially just copied the pattern from 411 and changed the number to 511. Nothing different, and yet it says "Call cannot be completed as dialed". ...
I have a ucm/uc/presence cluster that was on ver 8.6. Successfully upgrade both UCM servers, both UC servers, and the PResence server to version 10.5.I am not adding a secondary IM & P server. After installation completed, I activated all services,...
Hi all,I have some Cisco IP Phone 7911 running with CUCM 8.5.Default firmware is "SCCP11.9-3-1SR4-1S", but some of its run "SCCP11.7-2-3S".I don't know why because "Phone load name" is blank and if i don't wrong, this phone will run default firmware....
HiI have one problem comming in my CUCM installation. the error is NTP is not accessible.My installation equipments and operating systems.I am using ESXi Server 5.5 made a CUCM server machine.I am using CUCM 8.5my Vsphere is install on Win 7 64 where...
I am struggling a bit with setting up a call handler in Cisco Unity 7.0.We have a DID direct to the Unity administrator. They want the ability to dial the MeetMe conference numbers (799X) and dial into them from an outside line without having to cal...
Hi All,I am trying to do a message export using COBRAS on Connection 7.1.3, but it errors out saying this...7/6/2011 12:23:05 PM: ** Testing IMAP connectivity to Connection server for message extraction **7/6/2011 12:23:06 PM: (error) Failed to conne...
Hi, the BE6000 is quoted as being limited to 100 agents, 10 supervisors :http://www.cisco.com/c/en/us/products/collateral/unified-communications/business-edition-6000/qa_c67-703226.htmlDoes that refer to configured agents, or concurrent agents?Only a...
HiI have a BE 6000 currently running CUCM ,IM &Presence and unity applications . I wish to implement Mobile Remote Access , for that could I install Expressway E and Expressway C applications on the same BE 6000 ? regardsAneesh
