Hello everyone!We have ASR1001x with fullview and ipsec tunnels. We use local policy to forward packets from PA addresses to their respective gateways. When the traffic load is high PBR stop working and the router starts using cef, when there is litt...
Hello guys,I have two n9k switches and I have l2vpn evpn af configured in the default vrf paired with another pair of n9k for vxlan evpn purposes - that works fine but as soon as I get up ipv4 bgp neighborship from my vrf all ipv4 routes are leaking ...
Hello guys, I've purchased a catalyst 3560 multilayer switch for myself and I'm trying to configure two things:1. SSH 2. VLAN With SSH I'm able to get it up when creating any VLAN other than 1 but for VLAN 1 no matter what I do( assign an IP address,...
Hello, topology is attached.Please help me. how do I put the phone and PC on different VLANs and different subnets?If you could explain and paste the commands I'd appreciate it.
Hey guys,I'm new to cisco and I'm stuck.The goal is to set up one DHCP for all interfaces. I have cisco router 2911 and I'm able to assign different Ip addresses to different interfaces along with DHCP servers, however, I can't figure out how to set ...
Yes, so for example you have an IP address of 1.1.1.1 and your PBR says nexthop is 2.2.2.2 but you run a pcap on the interface with ip addess 3.3.3.3. When I ran a pcap these 1.1.1.1 packets showed up on the wrong interface meaning PBR didn't work. T...
Well, I actually mislead you, this issue persists regardless of the load. When I initially made packet captures there were little to no ESP packets but when I've adjusted the ACL for pcap I found them.
I've found the root cause of the issue:For locally generated traffic, the egress interface for non-encapsulated traffic (ISAKMP) is determined by local PBR. For locally generated traffic, the egress interface for post-encapsulated traffic (ESP) is de...
