Running into a weird issue at one of my client's sites. They are using a UC560 with a PRI trunk and about 40 phones. Every day the receptionist forwards calls coming into the main line to an answering service. Periodically the call-forward is removed...
Saw this at a client site the other week and then just replicated the problem on our production UC540 in house.Shared lines revert back to "normal" in CCA. Last week I removed all the extension and phones from the system and set them up again using d...
I have now run into this problem twice when setting up additional phones on UC540 systems with CCA 3.1 that were initially configured using CCA 3.0.Yesterday I was at a customer site replacing two SPA525 loaner phones with new SPA508 phones. I delete...
Trying to set up video monitor with CCA. I have a PVC 2300 up and running and can even see the device in the topology view in CCA. However, I can't seem to get the wizard to run.Any ideas?Thanks,Cole
I ran into an issue the other day when trying to start the TSW in CCA 3. I received the warning that I wasn't directly connected to a LAN port of the UC520.I am using a Macbook Pro with VMware Fusion and a Windows 7 VM for CCA. I assume that is where...
Ran a packet capture today while connected to a business Netgear modem/router and didn't get a single DHCPv6 packet.
The problem is likely that device is functioning as a full router and not a bridge like my modem at home is. In any case, it does see...
Using a SB6183 as well. Good eye on the RA packets. Seeing the same on my captures. Initially overlooked that.
Wouldn't surprise me if it is a Comcast issue. Their support naturally wanted to point the blame at the "customer owned modem". I have a te...
Confirmed the same problem (behavior by design) exists on the 5506. Also curious if the problem could lie in the Arris 6183 firmware and not on Comcast's upstream routers.
Hitting the same issue. Using Comcast as well.
Arris 6183 (Bridge/passthrough) -> Cisco ASA 5506-X (running 9.6.2(11)) -> My network
You might want to adjust your outside interface to include the following:
ipv6 nd reachable-time 3600000
I found...