About mplant

mplant · 02-03-2004

Hi all,I'm attempting to re-install Ciscoworks onto our Solaris 5.8 server, and keep getting the same erros:Installation of <CSCOcvw1> was successful.Application CSCOcvw1 CiscoViewERROR: Package verification failed : CSCOcvw1 aborting.=========...

mplant · 11-12-2003

Hi,Customer has Cisco837 (Site A) and a PIX 501 (Site B). working perfectly in a site-to-site VPN. A remote access VPN is configured on (B), but because of the PIX routing limitations, they of course can't access site (A). Has anyone has any success ...

mplant · 09-22-2003

Hi,I've got a two site VPN using routers. The VPN itself is fine, BUT - at the Head Office end, the customer has static NAT entries to allow incoming connections - any service which has a static NAT to allow incoming connections from the Internet is ...

mplant · 05-11-2003

Hi,I'm running CW on a Solaris 8 box. I can access CW happily from any other PC on my network, but not from the server itself. I've finally managed to get both Netscape (4.76) and Java working correctly, so I'm a bit stumped. I no longer get a "java ...

mplant · 05-01-2003

Hi,Customer has removed a static NAT entry and replaced it with a new one - uses the same original destination but a new NAT'd destination. "clear xlate" removes the old entry from the xlate table, but as soon as anyone attempts to access the host, t...

mplant · 02-08-2004

Absolutely perfect - exactly what I was looking for, thanks!

mplant · 11-25-2003

The idea is to use the PIX as the end point, not the central hub. I'm aware of the PIX's limitations in this regard.

mplant · 11-03-2003

Without more information about your DSL connection etc., I would say that you problem is caused by the Linksys attempting to run PAT on the IPSEC packets - IPSEC doesn't work in this type of configuration. You need to configure the "pass-through" opt...

mplant · 10-27-2003

Can you post your config, specifically the aaa-server and vpngroup sections?

mplant · 09-28-2003

That's what I thought I'd done, but the static translation seems to take precedence, even with the route-map in place. The router is running 12.2.(11)T2, btw.

Member Since	‎06-03-2002 07:06 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	23
Total Helpful Votes Received	9

User Statistics

User Activity

Ciscoworks Reinstallation problems

Hub & Spoke with VPN Client

Router to Router VPN, NAT and Statics

CW not accessible from server itself

PIX515 - Change of static NAT not taking effect until reboot?

Re: Ciscoworks Reinstallation problems

Re: Hub & Spoke with VPN Client

Re: VPN via DSL

Re: No user authentication prompt via windows IAS

Re: Router to Router VPN, NAT and Statics