Hi all,
I have the following question regarding SNMP and VSS:
I have the following device:
WORSC1-2#sh ver
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500e-UNIVERSALK9-M), Version 03.08.04.E RELEASE SOFTWARE (fc...
Hi Tobias,When you install the root patch to get shell access again, right after that you need to logout/login back to CLI to enable this password.If you want to make the root persistent you need to open a TAC case since I don't know such procedure.R...
Hi yprasannas,There are a couple of bugs for /var getting full: CSCvb45802 and CSCvb65492.Below links:https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvo65492https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvb45802You can try to apply the WA, but if ...
Hi Hilario,The recommendation is to open the TAC case and get into webex with the Engineer for him/her to provide you with the patch and do the procedures to recover the shell password, that patch is an internal file not available to customers for do...
In addition to the above, once you upgrade PI from 3.X to PI 3.5, at the CLI prompt that asks you to "disable the shell", please say NO, because if you say YES, you will disable the shell, forcing to perform the above procedure described. Regards,
Hello,
For this kind of issue is better to open a TAC case so the Prime Infrastructure Engineer can recover the shell cli access using a patch file. This procedure requires TAC to copy a RootEnable patch into the Prime defaultRepo, and install it ...
