Try moving your E1 card to slot 2, and configure it there. I was getting the same issue (using a T1 MFT card) when it was in slot 0. However I did not get the message when using slot 2.If this helps, please rate the post.Thanks!Chris
I assume you are using an ISDN line to connect to the PSTN via an H.323 gateway. This issue has to do with the bearer capabilities IE you are sending to the PSTN. If you run a 'debug isdn q931' trace on your calls, you should see output similar to ...
I assume you are using an ISDN line to connect to the PSTN via an H.323 gateway. This issue has to do with the bearer capabilities IE you are sending to the PSTN. If you run a 'debug isdn q931' trace on your calls, you should see output similar to ...