About Eric Turenne

Eric Turenne · 03-09-2015

Hello,I would like to integrate RSA SecurID to our current setup as a second factor authentication. I can authenticate with AD and RSA individually but not on the same authentication sequence.The scenario include the Anyconnect VPN where the user is ...

Eric Turenne · 12-04-2014

Hello, I have a problem where the switch will try to authenticate a device with MAB and it will never fail or timeout. Here is the situation: where a device has 802.1x authentication enabled but not it has invalid parameters (or missing certificate)....

Eric Turenne · 12-01-2014

Hello, I'm deploying dot1x in the office and I'm having little difficulty with enabling both dot1x with mab and then fail over to the guest vlan. A simple scenario where an end user device cannot provide authentication, I want the switch to automatic...

Eric Turenne · 03-10-2015

Hello David,I added the requested output in the attachment. I don't know where to look as I see two requests going to ACS but requests AD authentication only.Thanks,Olivier

Eric Turenne · 12-05-2014

Hello Neno, We use ACS 5.4 for Radius. I don't receive any status on the Radius reports for dot1x authentication. I will receive a fail status when it does not find any matching MAC address in the Internal store. Here is the output after 10 mins for ...

Eric Turenne · 12-05-2014

Hello guys, Thank you for your replies but the switch will still 'hang' on MAB with the following configuration: interface FastEthernet0/16 switchport access vlan 155 switchport mode access authentication event fail action next-method authenti...

Eric Turenne · 12-01-2014

I found a solution where 'event fail action next-method' would likely trigger the next authentication method without failing over. I also removed the priority and order commands as the switch will process on the intended order. Here is the result: ...

Eric Turenne · 12-01-2014

You might want to activate periodic authentication. I have not tested it myself, but I believe this should help.

Member Since	‎08-01-2009 05:35 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	9
Total Helpful Votes Received	10

User Statistics

User Activity

AD and ACS/RSA two factors authentication

Dot1x issue: MAB authentication will never fail or timeout

Dot1x: not failling over to guest-vlan

Hello David,I added the

Hello Neno,

Hello guys,

I found a solution where

You might want to activate