Wireless

Hi, We currently have a large campus with several 2504 (25 ap license) wlcs installed (one in each main building). This means we have to log into each WLC to make any changes to the various WLANs that are spanned scross the campus, to keep them in s...

Hi Which New/Latest AP models recommended to use with  WLCs (8510/7500/5500) for better configuration and performance ? Thanks Karthi

Hai we have one customer with 5508 sso, its connected to two edge switches then edge  connected to core all trunk ,core is the DHCP server.The issue is clients can get ip but no traffic pass outside gateway at core. no error logged. Tested different ...

Hi there, Trying to address this problem on a Mac - is it possible to change MTU from here? Trying to connect to VPN in another country. Thanks!

I have a requirement to provide Hyperlocation services for a new deployment. Idealy I would like to provide this using the later 3800 series access points, but it does not appear that the Cisco Hyperlocation module is supported on the 3800 series acc...

Can in configure captive portal in WLC2504.Please help me

What version of the WLC software do you suggest to install - 8.3.102.0(ED) or 8.2.121.0(ED)?

Hi,  we are running a cluster containing 5 AP561, since today they are running firmware 1.2.1.3, before 1.2.0.2. There are per frequency 3 ESSID. On the main ESSID are up to 15 clients. Now i happens from each day some clients are unable to connect...

Hi All,I have read the part of the WLC config guide about rogue containment, but what does it actually do?It says it sends deauth and deassoc frames to clients of rougue access points. This to me actually seems like we are performing a DOS on anothe...

Hi, I want to connect cisco 892-w AGN router Wireless WAN to hotspot so that my device at WAN side can reach internet. Purpose is i have primary link as MPLS and want this hotspot link as Backup

Hi All, At my workplace, we have a setup which contains Cisco 5508 WLC's currently running 7.6, mainly to enable us to use the 3702 access points. These work fine with our Prime Infrastructure device, which is running version 2.2.3. There is no upgr...

Hi, can anyone share the best practice configuration for Cisco flex connect for 8.2 image...

Hi, 1 AP 1 Channel 36 rssi- 86 AP 2 Channel 36 rssi -51 In the above case the client which is connected to AP will face  slowness due to CCI when  AP1 is  talking to another client ?  2 AP 3 Channel 40 rssi- 62 AP 4 Channel 40 rssi -56 Thanks