Wireless

Hi,I have WLC 2500 with firmware 7.4.121.0. Problem is with multicasting (or media streaming). One big boss wants his camera communicate with tablet, ant this communication requires multicast.In MONITOR-> Multicast I can devices trying to communicate...

I need enable AVC on WLC 7.5.103.1 and Cisco Prime 2.2.0 , but i can not make it. I enable Netflow Monitor and Netflow Exporter in WLC. The IP 172.21.23.19 is Cisco Prime, but when i go to Cisco Prime i do not see the Application Visibility & Control...

me podrian ayudar con la configuracion de un aircap 1600 series

Hi Guys,Been tasked with investigating poor performance on one of our APs at a remote site. Reports are of clients 'dropping off the network'. Initial diagnostics shows ping times as below (local layer 3 switch svi to wireless device): monl3s01#ping ...

We have some HP ProBook 470 G1 notebooks that are unable to reauthenticae to a EAP-TLS WLAN after they come back from sleep/power safe mode of if they are trying to reconnect to the WLAN after they have been disconnected.We are running two WISM with ...

I have configured a 1532 AP in Autonomous Mode as a Workgroup Bridge.It is working perfectly using the 2.4ghz radio but when I try the 5ghz radio I get an error Cannot associate - no response. I have 4 antennas connected into all the external connect...

Hi every one I have here Cisco Aironet 3700 I need to create ip default-gateway for Dhcp server But I do not know Can anyone help me i have here error messageThanks  

Hi experts, How can I create a 'read only' access user account?  There are only 3 type that can be selected (lobby admin, management user & network user).  Regards,Manuelito 

Hope you can help me here folks, I have configured a wireless bridge using 2 x AIR-SAP2602E-E-K9 over a distacne of about 80 metres.This is working well at speeds up to 54Mb, however I was hoping to reach over 200Mb using 802.1N technology, would app...

I know this is a Cisco forum, but I need help finding a good wireless solution and I highly respect the advice and assistance I get from the other members of this community, so I thought this would be the best place to go...Back in the day, I used to...

I have a new 1602i standalone AP trying to use RADIUS authentication.  For some reason the 1602 cannot ping the RADIUS server, but will get a response from other devices.  Both are on the same subnet, the new one at .213 and the RADIUS at .209.AP6#pi...