Wireless

Is there a way traffic can be prioritized by ssid, so that the traffic authenticated to one ssid gets preference over another?  How can I guarantee performance for one ssid over another?  The code version on the controllers is 7.0.240.0. They are 440...

Hello,   We are currently in the process of migrating from  WiSM  to WiSM-2. We have a Guest SSID Anchored with 4400 WLC. Previously on WiSM, we had QOS profile configured with a limited bandwidth and it was working fine up and down stream. After mig...

hello, I attached to this email architecture to deploy. the rukus radio link is operational, and the AP in 1552 that is connected in this building is saved on my WLC. I change its role to MeshAP RootAP. I enabled ETHERNET BRIGHING. But other AP 1552n...

Hi AllI'm working on getting internal WebAuth to work on a FlexConnect local switched SSID. From what I've been reading, it's possible but apparently not very straight forward. FlexConnect AP - if the SSID isn't local switch, WebAuth of course works ...

We are seeing an issue with an ipad connecting to a WLAN configured for EAP-TLS using ISE 1.2, getting disconnected.  The ipad will hop top another SSID.  It will connect back to the other ssid when selected.  Any ideas? I have a debug client for whe...

Hi guys, My company recently bought a new ap 1600 series which is not supported with the version i was using on my controller and i need to upgrade it to the latest version.We've requested for the latest version and our supplier send as two files "St...

Guys, I have a question regarding LAG ports. From Rajan's post here https://supportforums.cisco.com/document/81681/lag-link-aggregation he mentioned the following: When you enable LAG, all ports participate in LAG by default. Therefore, you must conf...

Hello,I recently upgraded WiSM2 controllers to the 7.2 release and have found that quite a few Accounting Start and Stop packets arrive at the RADIUS server without the Framed-IP-Address.. We use it to login the wireless user into SCE so they are not...

I have some 1130AG (autonomous ) AP's that are working fine.But clients connected to one of them recently starts to have extremally poor connection quality.As channel (1) being used is occupied - decided to change to 6 - after that change (and only t...