Wireless

I have a Cisco Secure Access Control System (ACS) that uses the Cisco Secure Access Control System 5.4.  It provides a separate .csv template for adding, updating, and deleting user objects.  Adding and updating is fine, but when I use the delete tem...

Hi,I have a 2500 WLC and I'm going to setup DHCP server in 3750x switch, one of the DHCP pool will be issuing ip address for AP. So, in the DHCP pool I should include option 43, am I correct? If yes, may I know what is the exact steps to configure th...

Greetings,I'm reading that if the WLC client detail shows rates m7 - m15, then it must be a 40Mhz wide channel (bonded 20's). However, I'm seeing those rates on 2.4 clients as well, which would be impossible, since those are not bonded.   I'm looking...

I'm a newbie to these forums. In the WAP statistics there is a reliability measurement displayed as "reliability 255/255".Does anyone know what this reliability statistic means or how it is calculated?Thanks!Steve

Good morning.I'm planning to install a new WiFi infrastructure with WLC 5508 and AIR-CAP702I. The thing is that, reading on the CAP 702 data sheet, found that it supports from mobility software version Release 7.5:http://www.cisco.com/en/US/prod/coll...

Hi.....We have been running two 5508 WLCs in HA mode for a while now connecting 25 2602 APs. We disconnected the heartbeat utp cbale to change the positision of the standby WLC in the rack. We did not power it off. After we plugged back the Heartbeat...

Hi,I've read numerous postings here about Apple AirPlay / Apple TV on this forum but still haven't been able to configure my 1042 AP correctly to do robust airplay.The ap is in autonomous mode, no controllers involved.I have a working Cisco 871W that...

I am setting up wireless access points for a Church.I acquired a couple of 1131AG access points, and flashed them into Autonomous mode successfully. I used the CLI to configure them to provide WiFi, 1 SSID only (it's just for parishoner access; the o...

Hi guys, i want to install AIR-CAP2602I-x-K9 in Aruba island but i don't know which regulatory domain to be used there ? any help ?Regards,Amir S Ahmed

Hello Everyone,I tried adding a 5508 wireless controller to Prime but the process never completes. The controller goes into "Uknown Devices" and the collection status reads "Credential check in progress. Refresh the page manually to see the status". ...