hello all i have a cisco aironet 1300..unfurtunately i cannot access because i forgot the password and username.. how do we recover the username and password without affecting the commands encoded in the device ??thanks
So I figure I got an incorrect or corrupt IOS. I tried to perform the mode reset, but it starts to transfer and then errors out. Here's an example of what the output is at, and it just sticks here:IOS Bootloader - Starting system.Xmodem file system...
Sir,I have the 2606i configured with both radio 0(2.4GHz) and 1(5GHz) up. They are working. Both radioes should support N. But when I connect my laptop to it, the laptop is connectiong to one of the radio only and with bandwidth 54M only. How can I ...
Hi all,My anchor controller is placed after the firewall . Inside zone ISE has been installed. So for any radius communication between ISE and WLC , ports such as 1812 and 1813 should i need to allow ?Thanks,TS.
We're leveraging interface groups to break up broadcast domains into 24 bit nets while still providing ample IP space to clients associated to a specific WLAN. As I understand it the WLC should round-robin the interfaces to client...
Hi all,I'm looking for some advice on WLAN design best practices. I'm "overhauling" my companies current wireless infrastructure and i'm a little unsure how to implement this following "scenario":I would like to segment the WLAN into 6 separate block...
Hello Community,I am currently studying for the CCNP SWITCH exam and had a question about how VLAN ACL's operate in a specific instance. The book is not clearing it up for me:If I had the following configuration:VTP-Server-1(config)# ip access-list e...
Hello, I am looking into configuring Dynamic ARP Inspection and DHCP snooping on my network. While the configuration is pretty straight forward, I am not finding much information in regards to wireless deployments. My networks utilizes a single vla...
I have 2 WLAN SSID, one's working the other isn't! Recently one of our Controllers rebooted, and then one of of WLAN's stopped working. I've checked the configs and code and they are the same on both controllers. The WLAN that is not working I see th...
I have a customer have intention to get all medical devices on wireless however some of devices are on 802.11b. Their understanding is that if they use wireless AP running a/b/g/n, if any 802.11b client connects , all would be downgraded to 802.11b e...
Hello,I have a client who can not authenticate on an autonomous Cisco wireless AP with his special WLAN client?Result: Authentication mismatchIf I use a TP-Link or Netgear AP, the specific wireless client can authenticate! No problem.All other wirele...
I was wondering if there was a way to include additional AP configuration information on the controller. I'm trying to program the following on some Aironet 1602s:1. Program the timezone to Eastern2. Program daylight savings to EDT (recurring)3. ...
Dear all,i 'm wondering whether the AIR-SSB350-E-K9 is replaceable with AIR-3602-E-K9? currently the 2 AIR-SSB350-E-K9 are used for outdoor bridge purpose so it is working with cisco Aironet 13.5-dBi Yagi Mast Mount Antenna (AIR-ANT1949), appreicate...
I am having an issue where clients dis-connect and re-connect anywhere between 2-6 times an hour. This can be a short outage (seen by citrix dis-connecting and re-connecting) or a drop out with task bar reporting limited access (infrequent)Observatio...
