Wireless

hi,we have two wlc connected to two Nexus (WLC1 hangs off Nexus 1 and WLC 2 hangs off Nexus 2). Both Nexus are connected using vPC. when i connect an AP to join to the network for some reason the AP cant only see one WLC. so the first time it connect...

Hi Team,We are running virtual TACACS( Cisco ACS), need to check if Centrify is supported on these appliances?We want to install monitoring tool agent on this devices? I meane centtify agent on this device?Please advice is it possible.Regards,Kannan

Hello,I have the following room to cover with wifi coverage. There are 10 concrete pillars in the room. Can you please advice which Cisco APs and antennas will provide an optimal solution for covering this room.Thanks!

Are there any features in Prime Infrastructure that would require you to build a larger Virtual appliance? The example would be if I add the assurance licenses and turn on advanced traffic monitoring. I am planning to build a medium virtual applianac...

I have a few 1142N Aironets with internal antennas in place, and I am not thrilled by its coverage. I want to extend my wireless network because of a new building which led me to the following question;Is there is any difference in wireless coverage ...

We are planning to upgrade our current wireless access points (1200 series) to 3600 series. We would also like to add a wireless access controller to the design to centrally managed those Access Points.Which Cisco Controller model  support those 3600...

HiI had a 2106 running 4.x software. It was upgraded to 7.x but will not read the config.Can anyone tell me how to downgrade the software?Sent from Cisco Technical Support iPad App

I had configured one access point CAP3602E in flex connect mode through a WLC 5508 after deploying the access point in flex control mode the local mac-filering is not working. before it was working when ap was in local mode. any body have to know is ...

Hi,     The issue I'm experiencing is that for some reason some AP's are terminating the association to either one of the controllers for a short period of time. When this happens and the AP re-associates itself with either of the active controllers,...

Can you please provide me with a sample configuration of c1310 as a workgroup bridge.

Hi all,I am running into an issue with disabling the web-auth secure web on an 5508 anchor WLC running 7.2.110. After the WLC rebooted, the guest authentication portal didn't show up...I could see the IE tab showed Web Auth Redirect though...Changed ...