Hi, we have replaced a Core switch (6500-VSS) that was connected to the ACI Border leafs. The new core SW is 9500 virtual-stack wise that connects to the same border leafs but on different ports/vpc. We have several EPG extensions that use static por...
Hi All,We have 300+ EPGs in our Environment and some of them are not used.Is there a Moquery to list all the unused EPGs?
Hi Could anyone please let me know what is a difference between Subnets in EPG and Subnets in BD?
Hi,So i fired up ACI Simulator using ProxMox Hypervisor.I have set my static IP as follow:IPv4 address: 192.168.1.200/24Gateway: 192.168.1.1the IP address is free and available in my network.The subnet is correct.The gateway is correct.However, i can...
Hi FreindsI Heard that u can Integrate ACI Simulator with vmware VCA using Mgmt Tenanant using the the Mgmt IPs for both ! so that you can push PG to VC and Play Around , any walk around Thanks
We currently have 2 pods with 4 spines in each pod. Our current configuration is to only use 2 of the spines in each pod for the IPN between the pods. This gives us no single point of failure. Given there are no bandwidth constraints between the s...
We would like to integrate Microsoft azure peering service. We would like our Pod5 and Pod6 to be able to communicate with the Microsoft azure peering service. The two Pods are interconnected with each other through the IPN network. We have inter-...
Hi Guys,I have non-production ACI fabric and I was in a multi-pod setup with POD-1 having two spines and POD-2 having one spine. All spines from both PODs are connected to a single IPN switch.I replaced the old spine switch in POD-2 (C9336PS switch (...
We have a need to send an ERSPAN outside of the fabric to a device that has inline taps attached. Am I correct in assuming that if that device has Layer 3 Endpoint within ACI this is possible? I have configured a POC with a VM that is within the AC...
The short version of my question related is: does ACI Out-of-Band Contracts function the same as regular contracts, flow direction wise? The long version is:Say you would like to create contract(s) and External Management Network Instance Profiles to...
Hi All, I need your assistance to check if the following configuration going to work and are there any drawbacks/caveats?So far I identified OSPF convergence time and impact on a relatively large area 0 *(legacy design). Solution details:I have ACI M...
Hi All,I'm currently deploying ACI Multipod with two pods.I've configured a single VRF and single BGP L3Out that connects the leaf switches within each pod to our core network. This L3Out is then assigned to each BD which results in the the associate...
Hi All,I'm currently designing an ACI solution for a single customer that wants to use multiple tenants for different business functions (prod, dmz, dev etc) whilst using the same physical infrastructure. For ACI, I typically configure separate VLAN ...
Hello everyone,I'm reaching out to the Cisco community for assistance with a problem I'm encountering regarding the assignment of a Provided Contract to vzANY in Cisco ACI. I've tried various solutions but so far haven't been able to resolve this iss...
Hello when a BD subnet is advertised over an OSPF L3out, i'm seeing tha subnet as E2 external route with metric 20 on the router connectd to BL (VPC link). Why the subnet is shown as external and not internal OSPF route? Why the metric is 20 ? Regard...
