Verify Root Guar

[neil0367389]

Hello all,

I hope all is well.

I just had a small question about how to verify that root guard has been enabled on a interface after running the command:

Switch#(config-if)#spanning-tree guard root 

I have tried a few show commands and I have tried looking through cisco docs but I cannot find anything.

Thank you

[Reza Sharifi · Accepted solution]

Hi,

Try

sh spanning-tre interface tenGigabitEthernet x/y/z detail

sh spanning-tre interface GigabitEthernet x/y/z detail

HTH

[MHM Cisco World]

@Reza Sharifi correct

[neil0367389]

Thank you  and sorry for the late reply.

[neil0367389]

Thank you so much and sorry for the late reply.