Hi Team,
I got 4 Nexus Dashboard Nodes. That i am setting up with for telemetry with Cisco ACI in a multipod setup.
What would be the most suitable way to place the ND appliances.
2 Master Nodes in POD1 and 1 Master + 1 worker Node in POD 2.
Also to...
Hi,
Have a Cisco Nexus Dashbaord with Insight. integrated with Cisco ACI. in the System Status Details, i see Telemetry Configuration Status "N/A"
Any idea why?
thanks
Nadeem
Hi,
In a multipod setup, the inband addresses will be from same subnet or differnet subnets for POD1 and POD2. There is just one inband EPG/BD. would it make sense to have two subnets in that BD?
thanks
Nadeem
Hi Team,
Trying to configuration EPL in my lab using CML. I have a basic 1Spine - 2 LEAF topology.
NDFC virtual appliance is running on ESXi with MGMT and DATA interfaces.
DATA interface can ping its default GW.
When I enable EPL, it picks the Serv...
Hi,
I setup a VPC with an external switch. VPC is UP. I have a network defined with anycast gateway. Same VLAN and SVI defined on external switch. The issue is I am only able to ping from one of the LEAF switch, not from both to the SVI on external s...
Hi, So I am back with the same question. I have a VPC with an external router and the VPC is using Virtual Link. I created one VLAN and SVI and added a VPC link towards external router. Leaf1 cant ping Leaf2 or external router. but Leaf2 can ping ext...
Here is the diagram based on yours. Its working when i enabled communication between loopback of Spine to the Nexus Dashboard Data interface. thank you for all your help. good advise
Thank you for your reply, i still havent gotten it worked yet. when you say ping ND Data IP Source x.x.x.x, is that the x.x.x.x loopback0 interface? so ND DATA IP need to reach the loopback of SPINE that is used for BGP?
