Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
According to http://www.cisco.com/c/en/us/support/docs/unified-communications/unified-communications-manager-callmanager/118893-technote-cucm-00.html Jabber clients do not support Security By Default. So if the CTL file changes (e.g Publisher certifi...
Hello, I have a CUCM cluster with two CUCMs located in the HQ (only one site). Sometimes when I make calls from specific IP phones I hear a robotic voice (internal calls only). I have changed my port configuration observing the same result. When I se...
Hi Collaboration Expert, Please suggest me about changing sip port number for configuration of Cisco Collaboration Edge (MRA). If is it possible then where needs to change in expressway site as well as cucm cluster site. Thanks in Advance. BR Niza...
Hello, we have a Cisco CME 11.0 system with IOS 15.6(1)T2, and since some time we are seeing the following log message: %VOICE_IEC-3-GW: C SCRIPTS: Internal Error (No dialpeer match): IEC=1.1.128.11.5.0 on callID XXXXXXX GUID=XXXXXXXXXXXXXXXXXXXXXX...
Morning, I need some assistance with an SQL Query. We are trying to determine what FXS ports have not been used and can possibly be re-purposed for other analog devices. I see in RTMT the counters for Calls Completed, but I am trying to get this inf...
Hello Everyone, I have a strange issue with one remote site. The setup is very simple: CUCM è H323 GW è FXO Card. The call is working fine for seconds or minutes, sometimes more than 10 minutes. Suddenly the call disconnects. I checked the debug...
Can't downgrade cisco 7912 from sip to sccp
Hi, Telco is sending 4 digit , here is my dial peer dial-peer voice 100 voip destination-pattern .. voice-class codec 1 session target ipv4:192.168.2.10 incoming called-number . dtmf-relay h245-alphanumeric no vad! and My extensions are 4 digit (...
Hi, Is it possible to make secure phone/jabber profile for encrypted communication without enabling mixed mode in cucm? We have currently cucm version 11.5. The reason for keeping the cucm to non-secure mode is , mixed mode cluster not supported by ...
Looking at compatibilty matrix , for 2900 series router 9.x is not supported. Can anybody confirm me whether am i able to upgrade or not?
Hi Concern, Please suggest me about security threats in IPT implementation in Banks with remote branches. Thanks in advance. BR Ahmed
Hi Team , Hi Team , I am trying to configure CDR for CME to an external syslog server . I have searched few online documents and found the necessary configurations as give below. CME-router #(config) service timestamps log datetime msec localtime ...
Hey Community,I got a Cisco 7970G IP phone that won't boot up after I did a factory reset. It was booting up prior to doing so. Here is what is happening when I plug it in:- Screen shows "Cisco Systems - Copyright 2002-2005, Cisco Systems, Inc", and ...
Hi All I installed CUCM 11.5, and 2 Gateway Routers, with 1 FXO card of 4 ports installed at eachI use in the 4-digit numbering (XXXX) of the IP Phones.My problem, I want to do a translation of outgoing calls from each group of directory number to an...
Hi, I have a Bluecom IP PABX. I am going to integrate it with CUCM. I want to bring directory numbers which are being used in Bluecom IP PABX to phones those will get registration to CUCM. How I can achieve it? BR AbdulKarim
