I am converting a customer from an old ccme 7.1 on a 28xx to CCME 11.7/12 on ISR4331. I have found that I can't call DNs that are not registered even if they are forwarded to a valid destination(voicemail or another DN that is registered), in fact I...
Good morning to everybody,We are looking to design a solution for a custormer which already has an on-premise solution with UCS.At this moment they are planning to integrate a new solution with some rooms for videoconference, MX most likely.They will...
Hello Experts,Warm Greetings.Now we are planning to deploy Cisco Expressway for MRA. We have two BE6K servers in two different geographiclly distributed datacenters (in the same country). Currently we delployed CUCM with Clustering Over WAN. Becasue ...
Hi Everyone,I did deploy Cisco meeting server app. I just noticeed that I have only a few layout on meeting windows but I can see many of layout type equel nineth, one plus n, one plus seven, one plus five ant stack, overlay etc. Can you please expl...
Can i connect CUCM BE6000 to third party call manger VIA SIP protocol ?
Hi, is it possible to use the CLI of CUE modul to download a Voicemailbox Greeting wav file? A running system needs to be replaced by a new one and we want to continue use the existing voicemail greetings. Regards René
Hi guys, I have this licenses for CUCM10.5 and CUC : SKUTotal LicensesQuantity FulfilledSmart License Converted Available QuantityBE6K-PAK11----UCXN-10X-SCPORTS22----UCM-10X-ENH-UCL2525----UCM-10X-ESS-UCL11----UCN-10X-VM-UCL2525----BE6K-UXL-START11-...
Hi Guys, Does anyone knows if Cisco IPT moving to Hyper-v in near future? Becauase there's some rumors that Cisco thinking to move to Hyper-v plateform soon? RegardsAdnan
if i have Polycom and Grandstream IP phones and both phones support SIP protocol can i regesiter these phones on the BE6000 ?
HiWe have configured SIP Trunk recently and have problem while creating inbound call from PSTN. We have used the command "debug voip dialpeer detail " inorder to make sure that our dial-peers function fine. I think my configurations from vgw-CUCM is...
Hi, We are using ASA5510 and configured the Expressway - E as DMZ. We have usual Static NAT and Security policy for internet to Expressway-E, Expressway - E to internet, Expressway-E to Expressway-C. We are planning to replace the ASA5510 to a ISR 43...
Dear All, I have configured SNR on CUCM 9.1. When Local DN(XXXX) dailing Remote Destination Profile Number(XXXX) is ringing on Mobile Number(05XXXXXXXX).When outside people (Ex: 05XXXXXXXX) dailing RDP Number its not rining on Associate Mobile Number...
Hello,Can anyone verify that the 3640 does NOT support network-clock commands? If not, how do you configure clocking for a PRI?Thanks,vp
Hi ,I configured CUBE with following config, but call doesn’t forward to hunt group when the users dial the 94352289022 . But SRST is functioning properly & when i dial 200 , all phones ring in the hunt. But doesn’t work with 94352289022 voice regis...
Hi I'm using D9902 DCM MKII V16.00.10 the SNMP is enabled and I download the SNMP files from the device FTP, I try to monitor the Streams traffic but when running snmpget command I getting "No Such Instance currently exists at this OID" Please advic...
