About TechLvr

TechLvr · 06-22-2023

You can configure your router to use SIP on the CUCM side and T1 on the carrier side.

TechLvr · 06-15-2023

Q1: Yes. Call Signaling and Call Control are the same thing.Q2: No. You RTP flow will be as below.Calling device --> CUBE (SIP Gateway) --> Redsky SBC --> PSAP

TechLvr · 06-15-2023

1. Creating an Intrado route pattern alone in CER does not impact anything.2. Check out link below for Conventional ERL to Intrado ERL migrationhttps://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cer/10_0_1/english/administration/guide/CER0_BK_CA6631...

TechLvr · 06-15-2023

I have configured ILS between CUCM 11.5 and CUCM 14.0 without any issues before.

TechLvr · 06-14-2023

1. For FXS rollover, use example below.trunk group FXSvoice-port 0/1/0 trunk-group FXS 1voice-port 0/1/1 trunk-group FXS 2voice-port 0/1/2 trunk-group FXS 3voice-port 0/1/3trunk-group FXS 4dial-peer voice 1 pots trunkgroup FXS destination-pattern 123...

Member Since	‎08-31-2022 01:17 PM
Date Last Visited	‎11-08-2023 07:03 AM
Posts	269
Total Helpful Votes Received	583

User Statistics

User Activity

Re: Inbound Calls T1 CAS MGCP to CUCM 14 Fail "Call Cannot Be com

Re: CER transition from conventional to redsky intrado

Re: CER transition from conventional to redsky intrado

Re: ILS Configuration between different version of Cisco CUCM

Re: Assistance with CUBE SIP-Profile and Outbound Dialing Config FXS