Configure Open Shortest Path First(OSPF) Update should be advertised only out of the interfaces that are indicated in the IGP topology diagram OSPF process ID is 47 Configure OSPF router ID with interface loopback 0 on respective router.What is the r...
1. Make end to end connectivity first. 2. Block the network for these site 1)Make sure that Site 4 will not advirtise any network to Site 5 which it receiving from Site3 routers. 2) On site 5 , when we check routing table of R2 router, it dont ha...
Or I won't know whether I am doing the wrong configuration first. Is there any rule for this to configure any specific Router first then go for another one?
I think in that figure only both interfaces are visible for Router1. Interface1- s1/1 and Interface2- s1/0. Both are changing state to down after some minutes.
