Wireless

4402 Reverse Telnet

Hi All, Not sure if this has been answered before or not but has anyone been able to get reverse telnet workig with a 4402 WLC (i am using a 2511 access router).I have tried manual configuration of the line but so far no success - the session appears...

Resolved! 5508 upgrade/backup controller

Yes

Is there a way to configure a 2600 AP without a console cable and a controller to set the IP address first?

Resolved! 3700e directional antenna

Guys,Please help me understand this. I am used to getting access points with omnidirectional antennas, however, i need an AP that can be placed on the wall (not ceiling) and send the signal in a certain direction only. For 3700i, the signal is basi...

WLC - AVC Reporting

Hi Experts, I was trying to figure out how the AVC reports capture the effects of implementing AVC!!Do we have any reports which show the optimization or prioritization provided to certain application traffic as a result of AVC feature?

WLC 5760 AUTHMGR-5-FAIL log

I am using the WLC 5760 My SSID use WPA2 PSK and i don't use ISE or Radius or AAA to authentication Some client can connect to the AP,but can not ping the gateway When i show logging from WLC,it will see the log like %AUTHMGR-5-FAIL: Authorization fa...

AVC Profile Configuration

5508 WLC w/ 7.4.110.0Is there a way to see all of the apps belonging to an Application Group and then select mutiple apps and assign, Drop/Mark actions?

Resolved! 5508 HA-SKU

Hi,I need to determine how the HA-SKU backup controller configuration is done, how it is different from SSO-HA. I need the procedure to implement.HA-SKU is different in that it employs two 5508's where one 5508 alone (AIR-CT5508-HA-K9) has the HA des...

Prioritize traffic by ssid?

Is there a way traffic can be prioritized by ssid, so that the traffic authenticated to one ssid gets preference over another? How can I guarantee performance for one ssid over another? The code version on the controllers is 7.0.240.0. They are 440...

Resolved! 7925 with 1.4(4) drops wireless association

I've been trying to upgrade a couple phones to 1.4(4). Call service is CME 8.6. The phone authenticates to network (WEP), downloads config files and attempts to register to CME, at that point the wireless link is dropped, "network busy" is shown. Ano...

QOS Profile not taking effect. 7.3.112.0 WiSM-2

Hello, We are currently in the process of migrating from WiSM to WiSM-2. We have a Guest SSID Anchored with 4400 WLC. Previously on WiSM, we had QOS profile configured with a limited bandwidth and it was working fine up and down stream. After mig...

AP 1552E Mesh not fonctionning

hello, I attached to this email architecture to deploy. the rukus radio link is operational, and the AP in 1552 that is connected in this building is saved on my WLC. I change its role to MeshAP RootAP. I enabled ETHERNET BRIGHING. But other AP 1552n...

Resolved! Reload Access Points after enabling broadcast of SSID

Hi, we've created a SSID, which is not being broadcasted. Now I would need to enable broadcast of the SSID-so my question is: how will the access points act after enabling it? Will they reboot automatically?? Or do they even need to be rebooted? Than...

WebAuth on FlexConnect Local Switched SSID

Hi AllI'm working on getting internal WebAuth to work on a FlexConnect local switched SSID. From what I've been reading, it's possible but apparently not very straight forward. FlexConnect AP - if the SSID isn't local switch, WebAuth of course works ...